Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Beholder DS1
Summary of Contents for Beholder DS1
- Page 1 TRD Beholder DS1 Camera Stabilizer...
-
Page 2: Table Of Contents
Beholder DS1. With TRD's years of experience in developing gimbals for handheld and aerial stabilizers a near perfect model is realized in the DS1’s design. DS1 improved payload of 3.8 pounds (1700 grams) ample, room for a camera’s flip- out LCD, and micro USB port for wired remote control. - Page 3 DS1 arrives pre-programed and ready to use out of the box. You can put your camera in any position including upside down and create continuous shots via remote control. With an extendable rod Beholder DS1 can also create crane, slider, dolly and time lapse effects with ease.
-
Page 4: Kit Includes
Be sure to install battery into the holder with positive side facing upwards in the battery holder. (Image2) Red: Battery being charged Red/Green: Battery charging finishing Green: Fully charged © 2015 Beholder All Rights Reserved... - Page 5 Screw on battery cap and make sure the cap is securely locked. Do not turn power on until the unit has a camera properly balanced ！ on it. Double check the battery compartment cap to ensure circuit contact is in good order. © 2015 Beholder All Rights Reserved...
-
Page 6: Camera Setup And Balancing
A. Attach the single sided anti slipping materials onto the adapter plate. B. Make sure the camera can be balance properly in all positions. Image A Image B © 2015 Beholder All Rights Reserved... - Page 7 C. Moving camera left and right(sideway) until balanced D. Adjusting quick release plate position on DS1 until balanced so it does not tilt up nor down. E. Moving camera back and front until balanced © 2015 Beholder All Rights Reserved...
-
Page 8: Start Up And Operation
A. 1) Only turn on the unit when there is a camera mounted properly on the stabilizer. Beholder DS1 utilizing a double IMU sensors and with a 32 bits processing technology, the stabilizer essentially can be started up and operated in any reasonable angles. - Page 9 B. Semi transparent plastic button is the power button, metal joy stick is a five ways multi mode control device. Press the power button once to activate the DS1 and the "Follow Mode" (a). Stabilizer will follow your hand position and synchronizing with hand movement and heading .Tilting up and down movement or...
-
Page 10: Versatility
DS1 will shut down to protect the batteries. Versatility A. DS1 can be easily attached to an extension rod or tripod stand for more versatile filming angles. B. Led lights can be attach to the USB for night shooting. -
Page 11: Possible Handheld Angles And Camera Position
Note 1. DS1 was tune to precise setting before leaving the factory, for whatever reasons, if fine tuning is necessary please refer to 4C (Gyro Calibration Mode) to return to factory default setting. -
Page 12: Specifications
3* 3.7v Li-ion 18650 2600mAh Battery: Range of Motion: 90-180° Yaw: 355° 355±180°(effective operating range) Pitch: 355±60° (effective operating range) Roll: 3~4 hours (depending on conditions, such as camera & lens weight, Battery Life: operating environments and settings) © 2015 Beholder All Rights Reserved...
Need help?
Do you have a question about the DS1 and is the answer not in the manual?
Questions and answers