Table of Contents
Advertisement
Case
The pedals are
Are the pedals connected properly?
not functioning
(p. 11)
Unplugging a pedal cord from the unit
while the power is on may cause the
The pedals
pedal's effect to be applied without
function
stopping. The power of the F-50 must be
intermittently
turned off before inserting or removing
a pedal cord (p. 11).
Reverb is switched on automatically
[Reverb]
whenever a demo song is played.
button's
Since each song has been supplied with
indicator lights
its own reverb settings, the way in
automatically
which reverb is applied changes when
you switch demo songs.
When the F-50 is connected to an external device
Is the power to all equipment turned
on?
Are the connections between F-50 and
the MIDI sequencer or the other
No sound is
external devices correct? (p. 22, p. 23)
produced
Is the MIDI channel setting correct? (p.
25)
Is the Omni On/Off setting correct? (p.
24)
Strange
sounds (or two
With the sequencer's "Thru" function
sounds) are
on, the same notes may be sounded
produced when
twice. Set the F-50 to Local off (p. 24).
the
F-50 is played
The volume
level of the
Could you be using a connection cable
instrument
that contains a resistor?
connected to
Use a connection cable that does not
the Input jack is
contain a resistor.
too low
Cause/Remedy
Troubleshooting
27
Advertisement
Table of Contents
