PolyVision CopyCam User Manual page 9

Userguide_RevA_4.fm Page 6 Friday, January 18, 2002 11:07 AM
To copy to a floppy diskette:
1 Insert a formatted diskette in the control pad, as shown below.
2 When you are ready to capture, press
board to the floppy diskette.
3 Continue your presentation after you hear the voice prompt say
"captured" and the LED changes from blinking yellow to solid
yellow. The disk drive begins to write after about 30 seconds.
Writing to disk may take up to a minute.
NO TE : NO TE :
If the LED blinks red, one of the following may have occurred:
No diskette is inserted in the control pad.
•
A bad or unformatted diskette is inserted in the control pad.
•
The diskette is full.
•
The voice prompt provides additional information.
To remove the floppy diskette from the control pad:
1 Wait until the LED changes to green or the voice prompt says
"ready," indicating that writing is complete.
6
to save a copy of the
COPYCAM OPERATION