Powered Swivel Seat; Powered Hinge - Acorn 180 User Manual

STAIRLIFT OPERATION
If a standard top finish rail is installed, the seat will be required to swivel
to enter and exit the stairlift.
When the unit reaches the upper end of the track, it will stop automatically.
The seat must now be turned to make getting on and off the stairlift safe.
To turn the seat, depress and
hold down the seat swivel lever
at the side of the seat pad.
This will then allow the seat to
be rotated to face the staircase
landing. The seat will lock
in position at 45º and 88º.
Make sure the seat is locked into position
before getting on or off the stairlift.
It is important that the seatbelt is undone
ONLY when the seat has fully swivelled and
it is safe to leave the stairlift.

POWERED SWIVEL SEAT

If a powered seat is fitted, (at the top of the stairs only), release
the direction controller on the arm rest and press again in the
UP direction. The seat will begin to swivel round automatically.
It is important that the seatbelt is undone ONLY when
the seat has fully swivelled and it is safe to leave the stairlift.
If a Powered hinge is fitted, the Stairlift will operate the hinge automatically.
When the lift reaches or leaves the programmed hinge zone, the Stairlift will stop
and the powered hinge will be automatically raised or lowered. This will allow the
user to operate the hinge whilst in a line of sight. At the bottom of the stairs, once
you have finished using the stairlift, pressing the up button on the remote handset
will automatically run the lift to either an intermediate charge point if fitted or the
top of charge point.
Before operating the powered hinge, ensure that the area is clear
14
SWIVEL SEAT

POWERED HINGE

Acorn Stairlifts User Manual
880 swivel is 450 swivel is
used on a used on a
standard size narrow size
landing. landing.
LANDING
LANDING
1