Page 2
Temperature Control Technology. For the best possible vaping experience please read, and follow, this user manual. The iTaste Kroma is powered by the Ultra-fast advanced AETHON chipset with 75W of pure power focused with ClearWave noise cancella�on technology. Choose your favorite Stainless Steel, Nickel200 or Titanium coils and get ready for an amazing vaping experience with no more dry hits! Pure Power, Total Control, Huge Clouds.
Page 3
Verify your iTaste Kroma is an authen�c Innokin Technology vaporizer: WARRANTY INFORMATION: 1) Locate the label on the packaging and scratch the silver to reveal your iTaste Innokin Technology provides a 90 day a�er sales service warranty to all authorized Kroma Unique Authoriza�on number.
Page 4
Please read this sec�on carefully to ensure you receive maximum benefits from other reproduc�ve harm. your iTaste Kroma and enjoy vaping with it in the most safe and effec�ve ways 3. This Advanced Personal Vaporizer has not been evaluated by the Food and Drug possible.
Page 5
10. In order to prolong the opera�on of your iTaste Kroma Advanced Personal due to the use of a low-quality charger. Only use the original iTaste Kroma Vaporizer, please do not place or store iTaste Kroma in excessively hot or cold Advanced Personal Vaporizer starter kit microUSB cable to charge the device.
Page 6
16. The iTaste Kroma Advanced Personal Vaporizer is not designed for use with a car charger. It does not come included with a car charger. OLED Display Screen Power – On/Off Bu�on / Make Selec�on “+” bu�on: Increase Temperature / Wa�age / Cycle Selec�on “-”...
Page 7
OPERATION GUIDE: The iTaste Kroma battery capacity is displayed via green, yellow and red LED The iTaste Kroma has three bu�ons: “ ” Power bu�on, “+” bu�on and “-” bu�on. “ ” Bu�on: Power - On/Off Bu�on / Make Selec�on Green = Almost fully Charged.
Page 8
Do not dry burn the coil. Always Prime new Coils before vaping. Always Always power off the iTaste Kroma when it is not being used, or when it is going to check & confirm the material and range of the a�ached coil.
Page 9
IMPORTANT: IMPORTANT: UNPLUG THE DEVICE BEFORE CALIBRATING. You must select the correct coil type. Set the iTaste Kroma Temperature or THE COIL MUST BE AT ROOM TEMPERATURE FOR ACCURATE CALIBRATION. wa�age according to the a�ached coil’s recommended range. CALIBRATING THE DEVICE AFTER FIRING IS NOT ADVISABLE AS THIS MAY LEAD TO INACCURATE READINGS.
Page 10
When the desired mode is selected press the bu�on “ ” to select Coil Type and Press the “ ” bu�on to lock the set temperature and ac�vate the iTaste Kroma. ac�vate the iTaste Kroma. The Fahrenheit Temperature Range can be adjusted from 300-600°F in 5°F YOU MUST select the correct coil mode before vaping.
Page 11
Dry Hit Detec�on & Preven�on: W Mode: Non Temperature Control coils. If there is insufficient eliquid in the coil, or if the coil is not primed, the iTaste Kroma output will drop to a low wa�age temperature maintenance mode. Adjust Variable Wa�age: THIS IS VERY IMPORTANT.
Page 12
If the “ ” bu�on is held for 15 seconds or longer the iTaste Kroma Advanced ture. The op�mal RampUp wa�age se�ng will vary according to the type of coil Personal Vaporizer LED will flash 10 �mes and then stop firing un�l the “...
Page 13
The screen will display “TOO HOT” if the PCB is overheated. resistance of the atomizer is lower than 0.07Ω, the LED will light solidly for 5 TOO HOT seconds, the Ohms bar will blink and the iTaste Kroma will not power on.
Page 14
If there are any issues with the device please contact your Authorized Innokin Remember last Temperature or Wa�age se�ng: vendor immediately. When the iTaste Kroma is turned off it will remember the current Temperature or wa�age se�ng and it will retain the se�ng when the iTaste Kroma is powered back on.
Page 15
How to refill the Slipstream Tank WHEN IS IT TIME TO CHANGE THE CLEAROMIZER COIL? All coils will need to be replaced a�er a certain amount of use. The �me between coil Refill with Tank: replacements will vary according to the eLiquid used and personal vaping habits. You 1) Push the top cap down and turn to open the tank.
Page 16
Replacing the coil: Product Features: 1) Push the top cap down to ac�vate the Child Proof Cap and Opera�ng Temperature Range: 150-315 °C 5°C increments turn counter-clockwise to open. 300-600 °F 5°F increments 2) Carefully unscrew the coil and Safely dispose of used coils Opera�ng Wa�age Range: 6.0 - 75W .5 wa�...
Page 17
Technical Specifications Ba�ery: 2000mAh Maximum output Wa�age: 75W Maximum output Current: 35.5A Maximum working Current: 27.5A Maximum output Voltage: 7.5V Atomizer Resistance: 0.1Ω (Minimum) Temperature Control Mode: Ni (0.1-0.2 Ω), Ti (0.1-0.5 Ω) Stainless Steel 316L (0.2-1.0 Ω) coils are recommended. Important: Temperature Control is only available with T.C.
Need help?
Do you have a question about the Kroma and is the answer not in the manual?
Questions and answers