Advertisement
Product Description
Thank you for selecting the Scamper robot kit as your next do-it-yourself project. This kit will
allow you to build an omni wheeled robot that can move in any direction. Using the demo code
and IR sensor PCB provided the robot will act as a spinning line follower.
The ComMotion controller is also an Arduino shield. Experienced users can add an Arduino
controller and use the ComMotion controller as an I²C controlled motor controller. We
recommend the SparkFun RedBoard as the larger USB socket used on many Arduino boards
can short circuit the ComMotion shield.
Product Features
1. High quality anodized aluminium chassis - light weight and strong.
2. Omni wheels with rubber rollers for better traction on smooth floors.
3. Metal geared motors with rear shaft for encoders.
4. Hall-effect encoder on each motor for precise speed control.
5. Pre-programmed ComMotion Shield with demonstration software.
Build it now! Realize your dream! Create your next masterpiece!
！
Warnings
Ÿ
Opened packages cannot be returned. Please check package contents before opening.
Ÿ
Read instructions carefully before assembling.
Ÿ
Use all tools carefully.
Ÿ
Small parts are a choking hazard. Keep this kit away from young children and babies during
construction and operation.
Ÿ
Not for children under 8 years. Not to be used by children except under adult supervision.
Ÿ
Observe correct polarity of the battery. Reverse polarity will permanently damage the
controller.
Ÿ
Keep dry at all times. Remove the batteries if the robot gets wet.
Ÿ
Do not mix battery types. Do not mix partially charged and fully charged batteries.
Ÿ
Do not use carbon-zinc or alkaline batteries. Use NiMh batteries only.
Ÿ
Remove batteries if the kit is not to be used for a long time.
Tools
The kit is supplied with all tools required to assemble it. The supplied spanner fits the hex
spacers, 3mm nuts and the nut on the switch. A small Philips Head screw driver is also
included for use with the 2.5mm and 3mm screws.
Advertisement
