Amc Configure > Network - Digital Alert Systems DASAMC User Manual

Digital Alert Systems
Setting Network
•
AMC Configure > Network
As previously mentioned, the AMC is factory configured with both a default IP Address at 192.168.0.210 and DHCP client. For
network administrators wishing to manage DHCP access the media access control address (MAC address) is printed on the
rear panel of the device. With this information a network administrator may assign a specific IP address to the unit from the
network DHCP server.
The current network settings will be displayed in the individual fields when this menu is opened. Modifying the IP address and
other network parameters will over-ride the current settings.
CAUTION: Improper or incorrect settings may result in no access and restoring the default settings may be the only way to
regain access to the unit.
Setting a Static IP Address
Using DHCP for IP Addressing
If the AMC found a DHCP server at start up those values would be shown in their respective fields. If there was no server or the
unit is switched to Manual the DHCP client shuts off. To use a DHCP server to assign networking values:
Resetting to default IP
If necessary, please contact the factory for information on resetting the default IP (support@digitalalertsystems.com)
Revision 3.0
AMS Installation /Operation & Integration Guide
1. Using the Configure IPv4 pull-down menu
select, Manual. The other fields are now editable
(Values shown at right are examples only and
may not reflect the required network values)
2. Enter the IP Address, the Subnet Mask, the
Gateway (Router) and any DNS Servers.
Multiple entries should be separated with a
space. (Note: Several features require Internet
access making these entries important to overall
operation)
3. (Optional): Enter any Search Domains the AMC
should look for simple or directed resolution.
Not required for standard AMC operation
4. To accept changes, click the Save button. The
system will immediately use the new settings,
this may require changing the web address or
refreshing the page
1. Select DHCP from the Configure IPv4 pull-down
menu.
(Values shown at right are examples only and
may not reflect the required network, moreover
any information displayed without an input box
were received from the DHCP server and are
non-editable)
2. Click the Save button.
The system will immediately use the new
settings. This may require changing the web
address or refreshing the page..
(Optional):
3. Enter any additional DNS Severs or Search
Domains in their respective fields. Multiple
entries should be separated with a space
4. Click the Save button
Not required for standard AMC operation.
Page 16 of 31