Product Maintaining; Cleaning Side Brushes; Cleaning Dust Bin And Filter; Cleaning The Rolling Brush - Pyle PUCRC750 Instruction Manual

Product Maintaining

Cleaning side brushes

1. Check the side brushes to see whether there are something
stuck on them.
2. Use a cleaning brush or mop to clean side brushes
(once a week).
3. Once the side brush is bent out of shape, put it in the warm
water for 5 seconds.
4. Replace the side brush once it is damaged.

Cleaning dust bin and filter

1. Press the "Push" on the main body of the robot to open the cover, take out the dust bin
assy.
2. Open the dust bin; take out the HEPA filter and the primary filter assy.
3. Empty the dust bin and wipe the dust.
4. Wash the dust bin and the primary filter by water; clean the HEPA filters with cleaning
tools.
5. Install primary filter and HEPA filter into dust bin.
6. Close dust bin cover and install it into main body.
Note:
a. The dust bin is suggested to be cleaned once a week.
b. Wash HEPA filters after 15-20 days' use. And replace it after use for 24 months at
maximum.
c. Install both HEPA and primary filters when they are dry.
d. Do not place HEPA and primary filters directly in the sun.
e. HEPA and primary filters could be replaced if needed.
14
Product Maintaining

Cleaning the rolling brush

1. Remove the rolling brush assy from the main body. Clean the hairs and furs tangled
on the brush. And use the cleaning tools or soft dry cloth to clean the brush and the
guard cover.
Note: For best result, clean it once a week.
Cleaning sensors and auto charging sensors
1. Slightly wipe the sensor window and auto charging sensors with cleaning tools or a
soft dry cloth, (see picture 2)
2. Clean charge connecting points on charging home base with a soft dry doth.(see
picture 3)
Note: Never let water, thinner, etc directly touch the sensor window. Clean them once a
week.
15