Baldwin Boxall ATTMR Operating Instructions

Table of Contents

Download this manual

IATTMR

Issue 1 22/09/1999

ATTMR

Operating Instructions

Baldwin Boxall Communications Ltd.

Wealden Industrial Estate, Farningham Road

Crowborough, East Sussex, TN6 2JR

Telephone: 01892 664422 Fax: 01892 663146

Website: www.baldwinboxall.co.uk

Email: mail@baldwinboxall.co.uk

Table of Contents

Need help?

Do you have a question about the ATTMR and is the answer not in the manual?

Page 1: Operating Instructions
IATTMR Issue 1 22/09/1999 ATTMR Operating Instructions Baldwin Boxall Communications Ltd. Wealden Industrial Estate, Farningham Road Crowborough, East Sussex, TN6 2JR Telephone: 01892 664422 Fax: 01892 663146 Website: www.baldwinboxall.co.uk Email: mail@baldwinboxall.co.uk...
Page 2 The basic unit will play tapes in the following sequence:- Both sides of tape 1 followed by both sides of tape 2. For a single ATTMR, this sequence repeats continuously. When a number of ATTMR units are connected together, the system will sequence through all tapes and then repeat.
Page 3 Mains Input: Use the IEC connection lead supplied, 230V, 50Hz. Fused Inlet: Use a T1A (1A anti surge) fuse only. Refer to qualifed service agent in the event of repeated failure. ATTMR SPECIFICATIONS CASSETTE DECKS (2 off) Maximum Play Time...
Page 4 ATTMR – CONFIGURATION / CONNECTIONS. STAND ALONE MODE. When a single ATTMR is used as a twin deck music system, the REMOTE terminals must be wired as follows: LINK Internally, link LK3 must be set to its MASTER position. SLAVE CONNECTIONS Several ATTMR units may be connected together to form a multi-tape system.
Page 5 MAN / AUTO Switch. INTERNAL LINK SETTINGS There are three links inside each ATTMR unit which determine if the unit is to be operated as a master or slave unit (LK3) and the cassette format in use.