Insignia NS-M16LED10 Quick Setup Manual

FEATURES
• Extremely bright and vibrant lighting for the
best possible quality from photos and videos
• Internal rechargeable battery does not drain
your phone battery
• Conveniently plugs into a headphone jack for
precise alignment with your subject
• 3 brightness modes (L - Low, M - Medium, H -
High) for fine tuning illumination
PACKAGE CONTENTS
• LED video light
• USB charging cable
• Quick Setup Guide
Before using your new product,
please read these instructions to prevent any damage.
Front
LED lights
Charging LED
3.5 mm connector
Left side: Right side:
Power switch
Brightness
switch
Micro USB port
CHARGING THE BATTERY
1 Slide the power switch OFF.
2 Connect the USB charging cable from your video
light's micro USB port to a power source (such as a
computer or USB power adapter (not included)).
The charging LED is red while charging, then turns
off when finished (about 2 hours).
Approximate Battery life (for each brightness setting)
Low 4 hours Medium 2 hours High 1 hour
Quick Setup Guide |
NS-M16LED10
LED Video Light
USING YOUR VIDEO LIGHT
1 Connect the 3.5 mm connector to your mobile
device's audio jack.
Note: The 3.5 mm connector is only used to secure
the light to your phone. It does not interface with
your phone. You may hold the light in your hand if
there is glare or your phone doesn't have a
headphone jack.
2 Slide the power switch ON.
3 Direct the video light at your subject and slide
the brightness switch to adjust the brightness,
as needed.
4 Use your mobile device to capture video or
images.