• The Presto must be used on a flat, level table. Never attempt to use it on a sloping surface or on a table that cannot accommodate the full footprint of the unit.
Page 3
• Never place any object on the screen. The screen can be scratched or broken easily and damage to it is not covered under warranty. Page 3 Presto User Manual Rev A EN...
Press the red button on the right of the front panel to turn the Presto on. The Presto will beep to indicate power-on and the lamps will light. After a few seconds, the image will appear on the screen. Page 4...
Page 5
2. Folding down and moving • Turn off the unit using the power switch • Unplug the power adapter from the Presto and also from the wall socket. • Remove all material from the reading table.
Page 6
Zoom Press the lower button to zoom out and reduce magnification. Press to select the image Brightness brightness and contrast settings you prefer. Press to power-on and power-off Power the Presto. Page 6 Presto User Manual Rev A EN...
Page 7
Press the power button to turn on the unit. Pressing the power button again (after the start-up screen has cleared) will turn off the unit. The Presto stores its settings only when it is powered off using the power button. If the...
Page 8
The Mode button is used to select the desired image mode. Repeated pressing of the mode button will switch from picture mode to positive to negative and back to Page 8 Presto User Manual Rev A EN...
Page 9
Brightness Control All three modes (photo, positive and negative) have four brightness and contrast settings. Press the brightness button to select the setting you prefer for the material you are viewing. Page 9 Presto User Manual Rev A EN...
Tiltable display. Low weight Magnification: X2.5 to x40 continuous zoom Temperature: 10°C to 40°C (50°F to 100°F) As we strive to constantly improve our products, this information is subject to change without notice. Page 10 Presto User Manual Rev A EN...
Page 11
DECLARATION OF CONFORMITY We, Ash Technologies Ltd., declare under our sole responsibility that this product, Presto, of the brand Ash Technologies to which this declaration relates, is in conformity with the following standards or other normative documents: EN 55022:1998 + A1:2000 + A2:2003 ITE – Radiated emissions EN 55024:1998 + A1:2001 + A2:2003 ITE –...
Ash Technologies or its agents. This warranty shall be voided in the event of damage or abuse caused, in the opinion of Ash Technologies or its agents, by dropping the unit. Cracks, scratches and pixel defects or similar damage to the display are specifically excluded from warranty.
Need help?
Do you have a question about the Presto and is the answer not in the manual?
Questions and answers