Troubleshooting - Hunter Hydrawise HC-1200M Quick Start Manual

TROUBLESHOOTING

My Expansion Module ID Color Is An Orange Color
• Check that you have added an expansion module for your controller in the Hydrawise
App (see section Hydrawise App Configuration above for instructions).
• Check that the configured Expansion Module ID on your Expansion Module matches
your Hydrawise controller configuration.
• Check that the master controller is connected to wireless.
All Expansion Module ID Colors Are A Grey Color
• You have not configured an Expansion Module ID on the Expansion Module. Touch
either button 1 or 2 on the Expansion Module to set the Expansion Module ID.
Expansion Module Zone Not Starting
• Check that the Expansion Module ID on the Expansion Module is a Green color and the
status is Online.
• If your old controller had a master valve (sometimes referred to as MV) then you must
configure a master valve in the app and wire this to a spare zone on the controller.
Detailed instructions can be found on the Hydrawise website.
• Check that your wiring is correct. If no solenoids start then check that your COMMON
wire is correctly wired.
Find more helpful information on your product? Find tips on installation, controller programming and more...
hunter.direct/hchelp
8
LIT-694-QS-EM US 10/16