Advertisement
5
Connect the Current Transformer
When performing this step, remember that high voltage may still be present on the temrinals of the
main breaker, so caution must be taken to avoid them.
Your Neurio Sensor will come with two CTs, but only one is necessary for a single-phase home. Keep the
other one in case you need it at a later date.
Clip the CT around the mains wire. In Europe, this wire is typically brown or black. Do not clip it around
the blue or green wires.
Plug this CT into Port #1 on the Neurio Sensor.
6
Connect the Antenna
In smaller homes, you may choose to simply connect the antenna directly to the Neurio Sensor and and
leave the antenna inside the CU. If greater range is necessary, then the cable and antenna mount should
be used to mount the antenna outside the panel.
Connect the antenna cable to the antenna connector on your Neurio. Feed the other end of the antenna
cable through either the 0.5" or 0.75" antenna mount. Use whichever size matches the knockouts in your
panel. Fasten the antenna cable onto the mount using the nut that is supplied on the cable. Then connect
your antenna to the antenna cable.
Find a 0.5" or 0.75" knockout that is within reach of your Neurio using the included antenna cable. Most
of the 0.5" and 0.75" knockouts will have an inner knockout and an outer ring. For either size, you only
need to remove the inner knockout and should leave the outer ring in place. Use a screwdriver to remove
the inner knockout. Feed the antenna mount through the knockout until it clips into position. For more
detailed instructions and pictures, refer to Step 6 of the 2-Phase Installation Guide.
7
Check Your Work
Now the panel should look something like this:
8
Close the Panel
Replace the cover on the panel and use the supplied Neurio breaker sticker to indicate which breaker
Neurio's black wire is connected to. Once the panel is closed and labelled, you can turn the main
breaker back on.
You're almost done! Refer to the next section, Installation Validation, to make sure that Neurio is installed
correctly. After that, the homeowner just has to follow the Welcome Guide to connect their Neurio sensor to
their Neurio account.
1
Mains Service Wire with CT connected and
label facing away from the main breaker
2
Neutral Bus Bar with Neurio's White Wire
connected
3
15A or 20A Single-pole Breaker with
Neurio's Black Wire connected
4
Antenna Cable, Mount and Antenna
5
Neurio's Red and Blue Wires capped with a
marette
Advertisement
