Part 4. Installation; Selecting Installation Place - Chigo CSG-07HVR1-A Technical Manual

R410A DC Inverter Multi-split Technical Manual

Part 4. Installation

1. Selecting installation place

Read completely, then follow step by step:

Indoor unit

Do not expose the indoor unit to heat or steam.

Select a place where there are no obstacles in front or around the unit.

Make sure that condensation drainage can be conveniently routed away.

Do not install near a doorway.

Ensure that the space on the left and right of the unit is more than 15cm.

Use a stud finder to locate studs to prevent unnecessary damage to the wall.

The indoor unit should be installed on the wall at a height of 2.0 meters or more from the floor.

The indoor unit should be installed allowing a minimum clearance of 15cm from the ceiling.

Any variations in pipe length will/may require adjustment to refrigerant charge.

There should not be any direct sunlight. Otherwise, the sun will fade the plastic cabinet and
affect its appearance. If unavoidable, sunlight prevention should be taken into consideration.

Outdoor unit

If an awning is built over the outdoor unit to prevent direct sunlight or rain exposure, make
sure that heat radiation from the condenser is not restricted.

Ensure that the clearance around the back of the unit is more than 30cm and left side is more
than 30cm. The front of the unit should have more than 200cm of clearance and the
connection side (right side) should have more than 60cm of clearance.

Do not place animals and plants in the path of the air inlet or outlet.

Take the air conditioner weight into account and select a place where noise and vibration will
not be an issue.

Select a place so that the warm air and noise from the air conditioner do not disturb neighbors.
112
GD Chigo Heating & Ventilation Equipment Co., Ltd.
Control System