Panduit CT-300-1 Operation Instructions

Contour Crimp
CONTROLLED CYCLE
CRIMPING TOOL
Crimps Panduit fully insulated
right angle disconnects for
No. #22-#14 AWG wire.
Provides UL Listed and CSA Certified terminations
with applicable Panduit disconnects.
Part No. CT-300-1
OPERATION INSTRUCTIONS
INSULATED DISCONNECT CRIMPING
INSTRUCTIONS
1. With the handles in the op n position, insert
the disconnect in the crimp pocket so that the
disconnect is fully seated within the crimp die.
2. Close the tool handles until the barrel is held
snugly in place—do not deform the barrel.
3. Insert the stripped wire into the disconnect.
Refer to product packaging for wire strip length.
4. Crimp the disconnect by closing the handles
until the controlled cycle mechanism releases.
Upon release, the handles
automatically and the crimped disconnect can
be removed.
Email:
techsupport@panduit.com
CT-300-1
© Panduit Corp. 2017
Figure 1
Verify power is "OFF" before
working on wiring with this tool.
will open
The cushioned grips are for the
user's comfort, and are not intended
to insulate against electrical shock
while working on electrical circuits.
www.panduit.com
OPERATION INSTRUCTIONS
CRIMP POCKET for
Pan-Term fully insulated
right angle disconnects.
Crimp pocket is identified
with applicable wire
range.
Controlled cycle
mechanism prevents
tool from opening
before crimp cycle
is completed.
Manual release lever,
push forward in the
event that controlled
cycle mechanism must
be released.
CAUTION:
Page: 1 of 2
Rev.: 02 1-2017
DISCONNECT
LOCATOR
Figure 3
RIGHT ANGLE DISCONNECT
Technical Support:
1-800-777-3300
PA24932A01
Figure 2