Related Manuals for NEO Coolcam NAS-DS01Z
Summary of Contents for NEO Coolcam NAS-DS01Z
- Page 1 Instruction Manual Door Sensor Thank you for your support Please read the instruction manual carefully before operating Please keep the instruction manual for further reference Shenzhen NEO Electronics Co., LTD...
-
Page 2: Product Introduction
Product Introduction Door sensor is an intelligent security equipment that can transmit the Z-Wave network which has particular frequency. In the Z-Wave network communications, door sensor can be connected to any Z-wave main controller. The door sensor can send messages to the Z-wave main controller, and realize association with other devices through the Z-wave main controller. -
Page 3: Product Configuration
Product Configuration LED light Door sensor main body Disassemble button Door sensor deputy body The code button Battery Sticker Screw stopper Screw Product List Door sensor main body Door sensor deputy body Battery 2pcs Screw 6pcs ... - Page 4 Including Sensor (Door sensor) to Z-Wave Network The door sensor can be included to the Z-wave network by pressing the code button. 1) Disassemble the door sensor main body and insert the battery. Make sure the device is located within the direct range of the controller. 2) Set the controller into the learning mode (see mail controller’s operating manual).
-
Page 5: Installation Steps
Installation Steps Door sensor Installation Battery Installation Door sensor Installation Option One Disassemble the door sensor main body and take out battery, fix it on the door with screws. Disassemble the door sensor deputy body and fix it on the corresponding door frame position ... - Page 6 Disassemble the door sensor Install battery Assemble the door main body sensor main body...
- Page 7 Tips When the door is closed, and the distance between the main body and the deputy is less than 2cm, the alarm gateway displays the door is closed perfectly. When the door is opened, the distance between the main body and the deputy body is more than 2cm, LED light flash and door sensor sends messages to the alarm gateway, the alarm gateway displays the door is open and alarms.
-
Page 8: Advanced Configuration
Restore the Sensor (door sensor) to Factory Default Settings Reset will delete all information on the Z-Wave network or Z-Wave controller, and restore the sensor to factory default settings. 1. Remove the cover of door sensor main body. 2. Make sure the sensor is connected to power source. 3. - Page 9 of dim level of lamp module shall be. Function: Basic Set Parameter Number: 2 Parameter Size: 1 Byte Available Settings：0, 1 - 99 or 255 0 – OFF, Alarm cancelling or turning a device off 1 - 99 or 255 – ON (Binary Switch Device) Dim Level (Multilevel Switch Device) Default Setting: 99 Command Classes...
- Page 10 Guarantee 1. The Guarantee is provided by Shenzhen NEO Electronics Co., Ltd (hereinafter “Manufacture” ). 2. The Manufacturer is responsible for equipment malfunction resulting from physical defects (manufacturing or material) of the device for 12 months from the date of its purchasing. 3.