Advertisement
Quick Links
July
Important safety instruction
1
English
Illustration
5. Bass trimmer
6. Line in
7. Output for satellites
8. Power cord
9. Power switch
Note: a. Audio only comes through the headphones when it is connected to the headphone
jack on the wired controller.
b.The wired volume controller will not affect the volume through the headphones.
3
English
Specification
Power output:
R/L: RMS 8W × 2 (THD =10%,
SW: RMS 12W (THD =10%,
Signal to noise ration:
≥85dBA
Distortion:
≤0.05%
Input sensitivity:
R/L: 450mV ± 50mV
SW: 70 mV ± 20mV
Bass unit:
5inch (131mm), magnetically shielded, 4Ω
Tweeter unit:
2¾inch (70mm), magnetically shielded, 4Ω
Dimension:
Subwoofer: 164(W) × 200(W) × 280(D) mm
Satellite: 120(W) × 151(W) × 125(D) mm
Net weight:
Approx. 4.2kg
Gross weight:
Approx. 5.2kg
5
English
1. Headphone jack
2. "Mute" switch
3. LED indicator
4. Volume control knob
=1KHz)
f0
f0
=80Hz)
M1380
Multimedia Speaker
Subwoofer
Satellite speakers
Wired controller
1. Connect the satellite speakers and the subwoofer
Connect the satellites to the speaker output port on the back panel of the subwoofer, using the 3.5mm connector
cable attached to the satellites.
2. Connect to audio source
Connect audio sources (like a PC sound card, MP4 player or CD player) to the wired controller, using the 3.5mm
connector cable attached to the wired controller.
3. Plug & Play
Adjust the master volume to a comfortable level to listen to music from any audio source.
Not all speakers function:
Please first check if the speaker wires are connected securely; then check if the Line-in connectors are reversed;
check also if the audio source is at fault.
One speaker does not function when playing CD from computer:
This kind of phenomena is prone to happen on new computer systems that one satellite does not function when playing CD,
but system works fine when playing WAV formatted files. This is mainly due to the fault connection of CD-ROM and sound card,
that one channel of signal is shorted to the ground. Please refer to the manual of CD-ROM and sound card to adjust the wire
connection.
System does not work at all:
1. Please check if power is connected, and if the wall outlet is switched on.
2. Please check if the audio source and audio input cable is connected correctly.
Noise coming from speakers:
Amplifier circuitry of this product generates little noise, while the background noise of some VCD/DVD player or computer
sound card are too high. Please keep the system in active mode and remove the audio source, if no sound can be heard at
1 meter away from the system, then there is no problem with this product.
Magnetic interference:
This system is complete magnetically shielded, and can be placed near TV or monitor. But since magnet of the subwoofer
driver is large, some magnetism leakage is inevitable when the system is too close to the monitor, and it is recommended
to keep a 1 meter distance between the speaker system and monitor or TV set.
If you have any further questions or concerns regarding Edifier Products:
Please visit our website at: www.edifier.com, or email Edifier Support for further assistance at: main@edifier.com,
If you prefer, you may contact us by phone, Toll Free: 1-877-EDIFIER (334-3437).
Packing list
Unboxing
What's in the Box
● 1 × Subwoofer
● 2 × Satellite speakers (with cable)
● 1 × Wired controller (with cable)
● 1 × User manual
Satellite speakers
User manual
User manual
User manual
2
English
Setting up
4
English
Troubleshooting
6
English
Advertisement
