Interphone F4XT Quick Manual

F4XT
F3XT
EN
QUICK GUIDE
WE RECOMMEND YOU CHECK FOR
SOFTWARE UPDATES ON THE WEBSITE
WWW.INTERPHONE.CELLULARLINE.COM
www.interphone.cellularline.com
6
1 - MFB (multifunction button)
2 2 - UP button
3 - DOWN button
4 - + volume button
5 - – volume button
4 8
7 - Multifunction LED
7 - Multifunction LED
8 - Multifunction audio/data port
9 - Mounting guides for Bluetooth® module
1 10 - Charging/audio-in connector
7
* see the user manual
3 5
for complete instructions.
8
9
A
B C
ASSEMBLY OF THE SLIDE SUPPORT
WITH REMOVABLE CLIP
Take the support and note the best place
to fasten it to the side of the helmet. Insert
the rear part of the clip into the helmet and
attach the other part on the outside.
Insert the screws and
tighten gently. Check
position and move the
PHASE 1 PHASE 2
support if necessary by sli-
ding it along. Tighten the
screws with the screwdri-
ver supplied.
(images A/B)
PHASE 3 PHASE 4
ASSEMBLY OF THE ADHESIVE SLIDE
SUPPORT
Take the adhesive support and look for the
best side and place to position it. Clean and
de-grease the part of the helmet where you
are going to stick the support (do not use
any detergents that could damage the hel-
met's finish). Remove the
protective film from the
double sided tape, and
apply the support to the
helmet.
PHASE 1 PHASE 2
As the support cannot be
moved once it is attached
to the helmet, take great
care with its positioning
when applying.
(image C)
PHASE 3 PHASE 4
B
A - YELLOW
B - GREEN
B
A
B
A
10
MOUNTING ON MOUNTING ON MOUNTING ON
FULL-FACE HELMET MODULAR HELMET OPEN FACE HELMET
MOUNTING ON
FULL-FACE HELMET
B
B
A
A
MOUNTING ON
MODULAR AND
OPEN-FACE
HELMETs
B
B
A
A