To Test the Electronic Stimulation:
1. Place the tester firmly on the
Collar Unit electrodes as shown.
2. Set the intensity level (a setting of
4 or less may not light the tester
due to its low intensity level).
3. Push the 'CONT' button.
4. The tester light will continue to light while the CONT
button is pressed (the higher the intensity level, the
brighter the test light becomes).
The first and most important step in training your dog
with your PetPal
correct Intensity Level to provide the proper training
stimulation without over-shocking your dog.
To do this, turn the Collar Unit ON and properly place it
on the dog's neck. Place the Intensity Selection dial so
that the System is set on Level One. Press the "Cont."
Button. If there is no reaction from your dog, increase
the Intensity Level in increments of one until the dog
feels the stimulation. You should be able to tell when the
dog feels the shock by outward signs of discomfort or
confusion on it's face. (Note: Some dog's may require
more or less stimulation depending upon their individual
nature or size.)
Selecting Proper Intensity Level
Training System is determining the
TM
TESTING
12