Mitsubishi SL2U Service Manual page 11

(3) Warning dialog window
1. The warning dialog window displays the error location.
Information displayed in this window depends on the
selected models.
2. "ERROR TIME (SET TIME)" displays the time when the
warning history data were recorded (the SET TIME in
the service menu). "ERROR TIME" and "SET TIME"
shown in the main dialog window are useful to know
when the error occurred.
3. Pressing the Detail button activates Notepad and opens
the file containing the information about the set and the
warning data. To prevent writing over this file, be sure to
select "Save As" from the "File" menu in Notepad to
save the file under a new file name. The name of the
file being displayed should be "DataTemp.txt".
4. Pressing the Warning Clear button displays the
confirmation message window, which asks you whether
you will clear the warning history data. Press the OK
button to clear the warning history data, or press the
Cancel button to cancel clearing them.
5. Pressing the Back button displays the main dialog
window again and carries out communication with the
projector again to get information from it.
Indicates which data of the
Warning Status, Warning History
1, 2, or 3 are displayed.
All the existing errors are
displayed red and their
check boxes are checked.
(4) Switching the COM port
1. Select the serial port to which the cable is being
connected. When the selected serial port isn't available
or doesn't exist, an error message window is displayed.
2. Press the OK button to switch the COM port. When the
serial port is switched correctly, communication with the
projector is carried out again to get information from it.
Displays the SET TIME
when the warning history
data were recorded.
Creates a Clears all the
detailed report. warning history data.
Warning dialog window
- 4 -
COM port switching dialog window
Goes back to the main
dialogue window.