Table of Contents
Advertisement
15
CONNECT THE LP TANK
1. Remove the plastic cover from the LP
tank connector.
2. Screw the regulator coupling (on the gas hose)
onto the LP tank connector in a clockwise direction.
Hand tighten only.
LP tank
connector
Regulator
coupling
NOTE: The regulator coupling tightens clockwise
and will not allow gas to flow unless the connection
is tight. The connection requires tightening by
hand only.
WARNING:
tighten the connection. Using a wrench could damage
the regulator coupling and could cause a gas leak.
The regulator vent holes should be at 3 o'clock.
They should not be pointed up.
16
TEST FOR LEAKS
WARNING —
check must be performed at the final use site.
DO NOT use grill until all connections have been
leak tested.
TO TEST FOR LEAKS:
• Prepare a soap solution of one part water, one part
liquid detergent.
1. Extinguish any open flame or cigarettes in the area.
2. Make sure the LP tank valve is closed and the grill
controls are turned to OFF.
3. Connect the LP gas tank. See the CONNECT THE
LP TANK step.
4. With a full LP tank, open the tank valve slowly.
Assembly Instructions
Regulator
(vent holes
at 3 o'clock)
Do not use a wrench to
A complete gas tightness
TEST FOR LEAKS
5. Wet each connection with the soap solution.
6. A leak is identified by a flow of bubbles from the
area of the leak.
7. If a leak is detected, close the LP tank valve, tighten
the connection, and retest (Steps 4–6).
8. If you smell gas, read and follow the complete Leak
Test section in the Owner's Manual.
9. If the leak persists, contact your grill dealer for
assistance. Do not attempt to operate the grill
if a leak is present.
17
INSERT THE DRIP PAN
• Insert the disposable aluminum drip pan into the
drip pan holder.
Drip pan
holder
18
READ YOUR OWNER'S MANUAL
Read your Owner's Manual carefully for proper use
and care of your grill.
11
(CONTINUED)
LP Tank Connection
Disposable
drip pan
Advertisement
Table of Contents
