Matter and Form V2 User Manual page 10

Follow the instructions for Calibration Steps 1 and 2 in the
so ware to calibrate you scanner.
The scanner turntable will rotate le and right, firing its
lasers and collecting a range of data. Be patient and do not
move the calibration card or scanner.
Step 2 will take slightly longer than Step 1 as the so ware
compares the data between Step 1 and Step 2.
If your calibration is interrupted or fails, an error
message should appear. Make sure your lighting
environment is ideal and the scanner is properly
setup before trying calibration again.
If a step in calibration takes longer than 30 minutes, stop the
calibration and try again or contact
support@matterandform.net
10
for tips and assistance.