Operating Rack Pdu Cards; Connecting To The Rack Pdu Cards; Operation Without Rack Pdu Cards - Liebert MPX User Manual

4.2 Operating Rack PDU Cards
Depending on the model of the communications module, see the Liebert® RPC™ Web Card User Manual
(SL-20825) or the RPC2™ Communications Module Installer/User Guide for instructions to operate a
Liebert MPX™ rack PDU equipped with a communications module.
You can download the manuals from the Vertiv Web site www.VertivCo.com.
4.2.1 Connecting to the rack PDU cards
After the RPC2 communications module is installed and configured, the card is ready to monitor and
manage Liebert MPX rack PDU receptacles.
If the card is not installed and configured, refer to
Configuring Rack PDU Cards
To connect to the rack PDU cards:
1. In a web browser go to http://192.168.1.10 to display the Liebert MPX rack PDU's web page.
2. When prompted for a username and password, enter the factory default values as noted in the
Liebert® RPC2™ Communications Module Installer/User Guide.
NOTE: For the RPC-1000 communications web card, the configuration capabilities are protected by a
username and password combination.
3. After entering the factory default username and password, change both for security purposes.
4. Configure or access information about the Liebert MPX rack PDU in the Device Explorer view.
4.3 Operation without Rack PDU Cards
Operating the Liebert MPX rack PDU without the optional rack PDU cards limits functionality.
To operate the MPX rack PDU without a rack PDU card:
1. After the unit is installed and assembled, verify the rack equipment is turned off.
2. Connect the rack equipment to the receptacles.
3. Connect input power to the MPX™ PEM and switch on the circuit breaker on each MPX™ BRM.
4. Turn on the rack equipment according to the manufacturer's instructions.
Vertiv | Liebert® MPX™ Rack Power Distribution Unit Installer/User Guide |
Installing a communications module
on page 33.
on page 26 and
36