Haier HW60-1081 Service Manual page 17

Service Manual
Model No:HW60-1281S/1081
Check if water is leaking from washer
bottom. inlet pipe. drain pipe or other
pipe connection.
Check if tap is closed or water
pressure is too low.
Check if the inlet value is jammed.
Draw out the dispenser and check if
water is entering.
Turn on power, and set pre-wash
mode, then start. Check the import
voltage of electromagnetic valve by
multimeter, is it between AC 220-240
V?
Check if export voltage from PCB to
electromagnetic valve, is it between
AC 220-240 V?
Cut off power, and check if motor
wire is connected well
Check if the wire of motor is
connected wellwith computer board.
Error message:The required water level is notreached within 8 min.
Error message:Motor speed error .it may be not properly connected
or damaged.
Readjust or replace the broken parts
Open the tap or wait for normal water
pressure to use
Clean the inlet value
Open the tap or wait for normal water
pressure to use drain pipe not reach
80. Observe if the height of em. If
water level the hose is leaking gas
Electromagnetic valve must be
broken, please replace it.
The wire connected PCB and inlet
valve is notproperly. Please
reconnect it or replace it.
Connect them well and test.
Connect them properly and test.
15
Issue
Rev.