How to Program the Transmitter
If you initiate a programming function by pressing pushbutton 1 and
LED 2 lights, the transmitter is already performing a task. You must wait
until the transmitter is free before programming.
LEDs will blink for one minute to display network quality after the
confirmation cycles for functions related to the network. See Function 1
- Display Network Quality for a detailed description of network quality
blinking.
Powering Up the Transmitter
•
Press and hold pushbutton 1 and 2 simultaneously
•
Count 5 blinks and release
The transmitter searches for a network.
Function 1 - Display Network Quality
Enables you to consult the signal quality of the link to the network.
•
Press pushbutton 1
•
Press pushbutton 2, count 2 blinks and release.
•
Press pushbutton 1.
After the three cycle confirmation sequence, LEDs will blink for 1 minute
to display network quality:
If there is no signal, LED 1 will blink once and LED 2 remains off.
If the signal is weak, LED 1 remains off and LED 2 will blink once.
If the signal is average (or mean) the LEDs will blink in sequence: LED
1 one blink, LED 2 one blink.
If the signal is strong the LEDs will blink in sequence: LED 1 one blink,
LED 2 one blink, LED 1 one blink, LED 2 one blink.
511398
5/07
301W User Manual
Honeywell
Using the Transmitter
How to Program the Transmitter
23