Input Voltage Configuration Warning - Garner HD-2 Series Operation And Installation Manual

Input Voltage Configuration
The HD-2 model is equipped with a voltage selection block allowing the HD-2 to be
configured for use in any country.
To check or change the voltage configuration of the HD-2, follow the steps listed below:
All trouble shooting and wiring checks must be performed by a
qualified electrician or authorized plant personnel.
Read the Warning
labels. All trouble
shooting and wiring
checks must be
1)
performed by a
qualified electrician or
authorized plant
personnel.
Remove the power cord
from the back of the HD-
2)
2.
Using a Torx T-20
driver, remove (3)
screws from each side,
3)
and (7) screws from
both the front and back
in order to remove the
top cover.
HD-2 Operation and Installation Manual
WARNING
Page 4