Fig-2 Egt/Cht/Tit Probe Placement - JPI EGT-701 Installation Manual

FAA APPROVED INSTALLATION MANUAL FOR THE EGT-701 Report 103
INSTALLING THE EGT-701 SCANNER® 1/20/09 Rev-E Page 23 of 30
Mounting bracket for the EDM-730/830
EDM-730/830 Model: Mounts in a standard 3.1/8" instrument hole. First place the mounting bracket on the
instrument and tighten the clamp hex screw until you can just remove the instrument from the bracket. The Mounting
bracket is then placed behind the instrument panel hole and screwed (6-32 x ½" screws) in place using the existing
holes. Three screws should be used leaving one hole vacant on either side of the hex screw. Locate the hex screw in
a location that you can easily get to from the rear of the panel. The body of the instrument is 3.0 inches and 2.0 inches
deep less connectors.