Weight And Balance Data; Changing Programmed Limits - JPI EGT-701 Installation Manual

FAA APPROVED
INSTALLING THE EGT-701 SCANNER®

27) Weight and Balance Data

TSO C43b, Temperature Indicator EGT-701
EGT probe MM-111
CHT probe 5050
Wire P.N. WK.-24 Harness 8 ft.
RPM, MAP, and Oil pressure
CHANGING THE PROGRAMMED LIMITS
40
Setting the K-factor (Fuel Flow Option)
You must set the K factor before using the EGT-701 with fuel flow. Note the K-factor that was engraved on the fuel flow
transducer.
1. Turn on the EGT-701 and after self-test, press STEP until the instrument is cycling normally.
2. Place the select toggle switch in the FF position.
3. Start the Pilot Programming Procedure by simultaneously holding the STEP and LF buttons for five seconds. You
will see the word PROGRAM for two seconds.
4. Tap the STEP button repeatedly until you see KF-SET.
5. Hold STEP and LF for five seconds. First digit blinks: 29.00
6. Tap or Hold LF to change flashing digit (for example): I9.00
7. Tap STEP for next digit: I9.00
8. Tap or Hold LF to change flashing digit: I8.00
9. Tap STEP for next digit: I8.00
10. Repeat steps 7 and 8 for the remaining two digits.
11. Verify the K-factor that was engraved on the fuel flow transducer is now displayed.
12. Hold STEP and LF for five seconds to exit.
13. Tap STEP
Setting the Data Recording Option Parameters
(Data Recording Option only)
If you haven't already done so, start the pilot programming procedure; simultaneously hold the STEP and LF buttons
for five seconds. You will see the word PROGRAM for two seconds. To change the date, time and user id for the Data
Recording Option, tap the STEP button until the display shows DUMP? N. Next, simultaneously hold the STEP and
LF buttons for five seconds. Then set the date and time as show below
Tap STEP to LF sequences
next item through these values
MNTH
I
DAY
I
YEAR
80
HOUR
OO
MIN
OO
USER ID N I2345
INSTALLATION MANUAL FOR THE EGT-701 Report 103
Month
I2
Day
3I
1980 through 2079
79
24 hour time. We suggest you set Zulu time.
23
59
Tapping the step will also zero the seconds (not shown)
Hold both STEP and LF buttons simultaneously until the first character flashes.
Use LF to select the first character. STEP moves to the next character.
Hold both STEP and LF to exit.
1/20/09 Rev-E
30 oz. / 1.9 lbs
2.0 oz. Each / 0.125 lbs
1.5 oz. each / 0.094 lbs
14.0 oz. each / 0.88 lbs
1.5 oz each / .094 lbs
Comments
Page 18 of 30