Motor Specifications And Electrical Requirements; Power Supply And Motor Specifications; General Electrical Connections - RIDGID OL50135AL Operator's Manual

Motor Specifications and
Electrical Requirements

Power Supply and Motor Specifications

WARNING:
!
To reduce the risk of electrical
hazards, fire hazards or damage
to the tool, use proper circuit
protection. Your tool is wired at
the factory for operation using
the voltage shown. Connect
tool to a power line with the
appropriate voltage and a 15-
amp branch circuit. Use a 15-
amp time delay type fuse or cir-
cuit breaker. To reduce the risk
of shock or fire, if power cord is
worn or cut, or damaged in any
way, have it replaced immedi-
ately.

General Electrical Connections

DANGER:
!
To reduce the risk of electrocu-
tion:
1. Use only identical replace-
ment parts when servicing.
Servicing should be per-
formed by a qualified techni-
cian.
2. Do not use in rain or where
floor is wet. This too is
intended for indoor residen-
tial use only.
The A-C motor used on this compressor
is a PSC, permanent split capacitor type,
having the following specification. It is
wired at the factory for operation on
110V-120V AC, 60 Hz service.
Voltage
Amperes
Hertz (Cycles)
Phase
RPM
WARNING:
!
Do not permit fingers to touch
the terminals of plug when
installing or removing the plug
to or from the outlet.
7
110-120
15
60
Single
3450