Table of Contents
Advertisement
Glossary of Terms (Continued)
Line Pressure Gauge
Displays the current line pressures. It is
regulated by the regulator knob.
Cut-in/Cut-off Pressure
Specific psi at which a compressor starts
and stops while refilling the air tank.
Unpacking and Checking Contents
1. Remove the air compressor from the
carton.
2. Place the compressor on a secure,
stationary work surface and look it
over carefully.
WARNING
!
Do not operate unit if damaged
during shipping, handling or
use. Damage may result in
bursting and cause injury or
property damage.
Installation
1. Check and tighten all bolts, fittings,
etc., before operating compressor.
2. Operate compressor in a ventilated
area so that compressor may be
properly cooled.
3. Compressor should be located where
it can be directly plugged into an out-
let. An extension cord should not be
used with this unit.
WARNING
!
For your own safety, never
operate unit until all assembly
steps are complete and until
you have read and understood
the entire operator's manual.
WARNING
!
To reduce the risk of injury, if
any parts are missing, do not
attempt to operate the air com-
pressor until the missing parts
are obtained and installed cor-
rectly.
4. To avoid loss of power and overheat-
ing, additional air hose must be used
to reach work area instead of exten-
sion cords.
10
Getting to Know Your Air Compressor
1
Regulated
Outlet Gauge
Figure 3
1. Regulated Outlet Gauge
1. This gauge shows at-a-glance, air
pressure at outlet. Air pressure is
measured in pounds per square inch
(PSI). Most tools have maximum pres-
sure ratings. Never exceed the maxi-
mum pressure rating of the tool you
are using.
2. Be sure this gauge reads ZERO
before changing air tools or discon-
necting hose from outlet.
2
Pressure Tank
Gauge
3
Regulator
Knob
4
Air Filter
2. Tank Pressure Gauge
Gauge shows pressure in air receiver
indicating compressor is building pres-
sure properly.
11
Hide quick links:
Advertisement
Table of Contents
