Accessory Installation Before Operating; Unpacking And Cleaning The Wine Cooler - Inalto IWCD46 User Manual

ACCESSORY INSTALLATION BEFORE OPERATING

UNPACKING AND CLEANING THE WINE COOLER

•
Remove the exterior and interior packing materials.
•
Let the appliance stand upright for approximately
it to the power source, which helps to reduce the possibility of a cooling-system
malfunction from handling during transportation.
•
Use a soft cloth to clean the interior surface with lukewarm water.
IMPORTANT: The front louver at the base of the appliance is for ventilation. Nothing
should be placed in front of this front louver; otherwise your Wine Cooler may not
operate properly.
o
should be made in the plinth with bigger size than the front louver. The
cut out is required whether the front louver is removed or not.
o The appliance is equipped with adjustable feet, so that the height may
o We recommend that two people carry out this procedure.
o The height must be adjusted prior to building the appliance into the
housing unit and it should be set at such a height that the top panel of
o Tilt the appliance approximately 60° to allow access
to the adjustable feet.
o Take care to ensure the cabinet is supported at all
times.
o Twist the foot into a suitable position to level the
cabinet.
o Repeat these steps for the other adjustable feet.
24 hours
.06.
INSTRUCTION MANUAL
before connecting