Unit controller operation and fault diagnosis (14 pages)
Summary of Contents for TemperZone SAT-3
Page 1
Important Note: This Quick Start Guide is for the purpose of installing a system with a single SAT-3 Controller. If you are installing a system with a second SAT-3 controller please see our installation manual Applies to: Zone Control Kit, part number 201-000-073 Software version 1.0 or later...
Page 2
When adjustment is complete press mode to exit installer mode. Cycle the power off for 10 seconds then on again at the isolator (not using the standby button on the SAT-3). It may take up to 90 seconds for the SAT-3 and zone control to begin normal operation.
Need help?
Do you have a question about the SAT-3 and is the answer not in the manual?
Questions and answers