Table of Contents
Advertisement
Settings (continued)
Use alternate J1708 address
There are two addresses that can be used by diagnostic devices to communicate with your vehicle. If
you are using a splitter to plug more than one device into your diagnostic port, communication could
be corrupted when both devices are using the same address. If you experience communication errors,
toggle "Use alternate J1708 address" to switch the ELD adapter to the other address.
Scan For Other ELDs
If there are multiple BIT ELDs in range of your phone or tablet, the app will connect to the nearest ELD.
You can check that you are connected to the correct device by the vehicle listed in your ELD Adapter
Settings or your Current Load Out on the Home page.
If you need to reconnect to the correct vehicle's ELD, tap "SCAN" next to "Scan for other ELDs".
Carrier Information
The Carrier Information screen lists your current Carrier and DOT Number. These settings cannot be
changed on the app but must be changed on the Blue Ink Tech website. Log in to
www.blueinktech.com
Account" page to join or leave carriers. As a driver, you will have access to all logs recorded under
your
account even if you are no longer driving for a particular carrier
with the same email and password you use to log into the app. Go to the "My
Driver Information
This screen shows your current information. You can edit
your driving cycle and commercial driver's license
information, time zone and language on this screen.
Your commercial driver's license number is required
before your logs and reports can be shared with a carrier.
20
(see My Account on pg 34)
.
Advertisement
Table of Contents
