Adding A Record Of Duty Status; Editing A Record Of Duty Status - BLUE INK TECH BIT ELD User Manual

Hours of Service (continued)

Editing a Record of Duty Status

There are some circumstances in which you may need to edit your
logbook for correctness. For example, you may forget to change
your duty status during the day or set the wrong status by
mistake.
To edit a duty status tap the "EDIT" icon to the right of the duty
status listed on the Hours of Service screen. This will bring up the
detail screen where you can adjust the time, select a different
duty status and modify your notes.
All edits to duty status require a note of at least four characters.
Your previous record will be marked as inactive and the new
record with your changes will be marked as active.
You can also delete a duty status, which will mark that record as inactive.
FMCSA Mandate Requirement: If the ELD detected the vehicle as in-motion, then a
change of status to a non-driving status will NOT be allowed. You will NOT be able to
add a non-driving status in the middle of a period of time detected as in-motion.
Messages will alert you if these conditions occur.

Adding a Record of Duty Status

To add a duty status tap the green "+" button and select "Add Duty
Status". This will open the Set Service menu shown to the left.
Tap the duty status you want to enter and add any relevant notes. The
time and location will be automatically filled out with the current
time and location.
Tap in the "Time at Home Terminal" field to change the time to insert
a duty status at a previous time. You may insert a duty status at any
time as long as it does not conflict with automatically recorded Drive
time.
You can also quickly set your duty status by tapping the blue circle in
the Current Load Out section on the Home page.
14