Be Modern 1122 Fire Installation And Operating Instructions

200671_5
User instruction for fan heater model: These instructions should be read carefully and retained for future reference

Important Notes

•
This heater must not be located immediately below a fixed socket outlet.
•
Do not use the heater in the immediate surrounds of a bath, a shower, or a swimming pool.
•
Do not cover this heater, or obstruct the air inlet or outlet, otherwise there is a risk of overheating.
•
The heater must be cooled down completely before any maintenance
•
This heater must be fixed against a vertical surface.
•
Under no circumstances should the heater be used as a free standing appliance.
•
After unpacking, please make sure that the appliance is intact, with no signs of damage caused by
transport. If in doubt, do not use the appliance and contact the Service Centre.
•
During normal operation this appliance will emit noise from the internal fan unit.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
•
This appliance and its handset are not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning the use and dangers of the appliance and handset by a
person responsible for their safety.
•
Children should be supervised to ensure that they do not play with the appliance or handset
•
Children of less than 3 years should be kept away unless continuously supervised. Children aged from 3
years and less than 8 years shall only switch on/off the appliance provided that it has been placed or
installed in its intended normal operating position and they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3
years and less than 8 years shall not plug in, regulate and clean the appliance or perform user
Maintenance.
•
Some parts of this product can become very hot and cause burns. Particular attention has to be given
where children and vulnerable people are in the vicinity.
•
Do not use this appliance as a primary heat source
•
Ensure that furniture, curtains and other combustible materials are positioned no closer that 1m from the
front of the fire.
•
Do not stand the fire on the carpet – stand on a firm surface, which projects 250 mm (10 inches) beyond
the front of the fire and is free of dust and lint.
•
If this fire is supplied through an extension cable, please ensure that it is the only appliance plugged into
the extension and that the instructions for the extension cable / reel are followed.
•
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut out, this appliance
must not be supplied through an external switching device, such as a timer, or connected to a circuit that
is regularly switched on and off by the utility.
•
This appliance must be positioned so that the plug / fused spur is accessible
•
In the event of a fault please disconnect the fire from the mains supply
•
Warning: This appliance must be earthed.
The wires in the mains lead connected to this appliance are coloured in accordance with the following code:
GREEN and YELLOW
BLUE
BROWN
As the colour of the wires in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured Green and Yellow must be connected to the terminal in the plug which is marked
with the letter E or by the earth symbol or coloured Green or Green and Yellow. The wire which is coloured
Blue must be connected to the terminal which is marked with the letter N or coloured Black. The wire which is
coloured Brown must be connected to the terminal which is marked with letter L or coloured Red.
2kW Electric Heater c/w Thermostat Control
Fire Installation and operating instructions: Models 1122
Earth
Neutral
Live
1