Command Line Parameters - IBM 1G User Manual

Command line parameters

This topic lists the command line parameters available for the Network Active Bypass unit.
The parameters are divided into the following categories:
v Management port
v Communication
v E-mail notification
v SNMP
v Operational
Use parameters with care
Use these command line parameters carefully, because they control the behavior of the Network Active
Bypass unit. Do not change a default value unless you are sure of the effect the change will have on your
network. Some parameters should not be changed unless you are instructed to do so by a representative
from IBM Support.
Management port parameters
The parameters in the following table control the IP settings for the management port.
Parameter
ip
mask
gw
current_ip
Communication parameters
The parameters in the following table control the communication features of the Network Active Bypass
unit. Use cli get to retrieve the current value for a parameter. Use cli set, plus the new value to
change the value of the parameter. For example, cli set ip 127.0.0.1.
Parameter
dns
dns2
domain
Chapter 4. Configuring the Network Active Bypass unit using the command line interface
Description
Current IP address for the management port for Network
Active Bypass unit
Default: 172.16.124.17
Subnet mask for the management port
Default: 255.255.255.0
Gateway IP address for the management port
Default: 172.16.124.1
Current IP address for the management port
Note: The current_ip parameter is read only.
Description
DNS server IP address
Note: This parameter corresponds to DNS 1 in the user
interface.
Second DNS server IP address
Domain name for the local host
Default: local
23