Monitoring The Status Of The Network Active Bypass Unit - IBM 1G User Manual

Monitoring the status of the Network Active Bypass unit

This topic provides information about using the management interface to monitor the status of the
Network Active Bypass unit.
Checking overall status
The Status page is the first page you see when you log in to the management interface. Use the Status
page to view information for the Network Active Bypass unit. The Status page provides information in
sections, as indicated in the following table.
Section
System
Power Supply
Segment 1
Segment 2
Segment 3
Segment 4
Tap Settings
Viewing system status
The System section provides general system status, as indicated in the following table.
Field
Product Name
Product ID
Hardware Revision
Firmware Version
Management IP
Email Notifications
Description
Provides general information about the Network Active
Bypass unit
Indicates whether power supplies are present or not
present
Shows the active/bypass status for segment 1
Shows the active/bypass status for segment 2
Shows the active/bypass status for segment 3
Shows the active/bypass status for segment 4
Shows current port configurations
Description
Displays the name of the Network Active Bypass unit:
"Proventia
Displays the product ID of the Network Active Bypass
unit:
"Proventia NAB rev 1"
Displays the hardware version of the Network Active
Bypass unit
Displays the current firmware version of the Network
Active Bypass unit
Displays the IP address for the management port
Tip: Use the Management Port page if you want to
change IP settings for the management port.
Default: 192.168.0.111
Indicates whether e-mail notifications are enabled or
disabled
Tip: Use the Email Notification page if you want to
change e-mail settings.
Default: Disable (Don't send)
Chapter 3. Configuring the Network Active Bypass unit in the management interface
®
NAB"
13