Replacement Parts List - Rheem 72V20-1 Use And Care Manual

Replacement Parts.
For 20–52 gallon models with single or double elements.
Some models may have
been supplied with
External heat traps
in lieu of Internal heat traps
Relief valve
Hot outlet heat tube
(on side connect models
only)
Shroud
Drain valve
Cold inlet nipple
(on side connect models
only)
Instructions For Placing a Parts Order
Address parts orders to the distributor or
store where the heater was purchased.
All parts orders should include:
The model and serial number of the
water heater from the rating plate.
Specify voltage and wattage as
marked on the rating plate.
Relief valve
Hot outlet heat trap
or dip cup insert
(on top connect models only)
Dip tube gasket
(on top connect
models only)
Anode rod
attempt repair of electrical wiring,
thermostat(s), heating elements or other
operating controls. Refer repairs to qualified
service personnel.
Dip tube (on top connect models only)
Top Connect Models
(see illustration below for other parts)
Upper thermostat*
Upper thermostat protective cover*
N OFF
TUR WE R
PO OR E
BEF VIC ING
SER
Thermostat bracket*
Heating element*
Heating element gasket*
Lower thermostat
Lower thermostat protective cover
Heating element
Heating element gasket
Part description (as noted below) and
number of parts desired.
CAUTION: For your safety DO NOT
Dip tube gasket
(on top connect models only)
Anode rod
Junction box cover
Plate cover
Junction box cover
Plate cover
Cavity insulation
Jacket access cover
Cavity insulation
Jacket access cover
Thermostat bracket
*These parts are supplied only on
double element models
17