Safety Information - Pioneer AVX-P7300DVD Service Manual

7 inch wide av system display/dvd player
Hide thumbs Also See for AVX-P7300DVD:
Table of Contents

Advertisement

AVX-P7300DVD
- DVD Player Service Precautions
1. Never adjust the LD VR in the pickup unit to protect the pickup from electrical damages.
2. For pickup unit(service)(CXX1530) handling, please refer to"Disassembly"(see page 109).
During replacement, handling precautions shall be taken to prevent an electrostatic discharge(set the short switch
of the pickup unit to the SHORT side).
3. During disassembly, be sure to turn the power off since an internal IC might be destroyed when a connector is
plugged or unplugged.
4. Please adjusting the skew after changing the pickup unit(see page 83).

1. SAFETY INFORMATION

1.1 UC
CAUTION
This service manual is intended for qualified service technicians; it is not meant for the casual do-it-yourselfer.
Qualified technicians have the necessary test equipment and tools, and have been trained to properly and safely repair
complex products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability of the product and may void the warranty.
If you are not qualified to perform the repair of this product properly and safely, you should not risk trying to do so
and refer the repair to a qualified service technician.
WARNING
This product contains lead in solder and certain electrical parts contain chemicals which are known to the state of
California to cause cancer, birth defects or other reproductive harm.
Health & Safety Code Section 25249.6 - Proposition 65
1.2 EW
1. Safety Precautions for those who Service this Unit.
• Follow the adjustment steps (see pages 80 through 100)in the service manual when servicing this unit. When
checking or adjusting the emitting power of the laser diode exercise caution in order to get safe, reliable results.
Caution:
1. During repair or tests, minimum distance of 13cm from the focus lens must be kept.
2. During repair or tests, do not view laser beam for 10 seconds or longer.
2. The triangular label is attached to the mechanism
unit frame.
2

Advertisement

Table of Contents
loading

Table of Contents