Setting Up The Machine - Bernina Industrial 950 Instruction Manual

Setting up the machine
Removing and inserting the bobbin case
4
Winding the lower-thread
Handwheel release
Release the handwheel
by turning the knob in the
direction of the arrow.
Winding
Place bobbin on the spin-
dle and press down.
The winding device starts
when the motor is put in
gear. As soon as the bob-
bin is full, the winding
device switches off auto-
matically.
Guiding the thread
Guide the thread clockwise round the
pre-tension stud to the bobbin and wind
it clockwise round the bobbin a few times
by hand.
Removing the bobbin case •
Open the slide plate. Hold the bobbin case by the latch
with the thumb and forefinger of the left hand and take
it out.
Inserting the bobbin case
Hold the bobbin case latch with the thumb and fore-
finger of the left hand. Lay the thread over the finger
and with the notch at the top, insert the case into the
hook so that it engages.
Thread cutter
Note:
Tighten the handwheel release after win-
ding the lower thread.