TH Series
Wiring Diagrams
There are several ways that TH systems can be configured so we will now look at some practical wiring examples for the most
common system configurations.
System A‐ basic set‐up bi‐amping THV or THH
This is the most simple system set up for stereo operation, connecting from your source, often a mixer, straight to a DX0.5 (or
other system processor) using balanced XLR "microphone" cables. From the DX0.5 we take four outputs, two low frequency and
two high frequency and these are routed to the two amplifiers. We then use a speaker cable that combines two Neutrik NL2 or
NL4 Speakon connectors into a single 4‐core speaker cable to go from the amplifier outputs to the TH speaker inputs. This could
also be achieved with a custom patch panel using NL4 panel connectors with short speaker cables routed from pins 1+/‐ and 2+/‐
on the panel to the high and low frequency amplifiers. This will allow a standard 4‐core speaker cable can be used between the
panel and TH speaker.
See the chapter on amplifier selection to choose the most appropriate amplifier for use with the TH cabinet.
TH Series User Guide V1.0
USER GUIDE
14