Locate - RIDGID SeekTech ST-33Q+ Operator's Manual

Locate

Note: When the ST-33Q+ is powered on and in Direct
Connect Mode, only hold the cable leads by the plas-
tic sheathing. Do not touch the metal scraper tip, teeth,
or magnet.
1. With one cable lead attached to the ground stake
and the other attached to the target conductor,
press the Power key
Upon start up, the ST-33Q+ measures the current
flowing through the target conductor and beeps to
indicate output. Faster beeps indicate a higher out-
put current.
2. Select a frequency by pressing the Frequency key
until the desired frequency appears or press-
ing and holding the Frequency key to show a list
of available frequencies. Press the Up and Down
Arrow keys
desired frequency is highlighted, press the Select
key to activate it.
Note: In addition to the default frequencies, the ST-
33Q+ can also accept custom frequency settings
up to 490 kHz. See the section on adding custom
frequencies in this Operator's Manual for more de-
tails.
18 – English
Find Quality Products Online at:
to power on the ST-33Q+.
to move through the list. When the
GlobalTestSupply
www.
3. Follow the instructions in the receiver's Operator's
Manual to power on and use the receiver. Ensure
the frequency on the receiver matches the ST-33Q+.
If the receiver signal increases when held near the
ST-33Q+, it is correctly picking up the transmitted
frequency.
4. Adjust the current as needed during the locate by
pressing the Up and Down Arrow keys
ST-33Q+. In Direct Connect Mode, the ST-33Q+ in-
creases the current as close to the following levels
as possible:
• 25 mA
• 50 mA
• 100 mA (default)
• 200 mA
• 400 mA
5. After completing the locate, press the Power key
to power off the ST-33Q+.
Note: To reduce the risk of electrical shock, power
off the ST-33Q+ before disconnecting the leads
and remove the lead from the target conductor be-
fore removing the lead from the ground stake.
.com
on the
sales@GlobalTestSupply.com