Check List - YUNEEC H520 Maintenance Manual

CHECKLIST FOR INSPECTION
Owner:
Tested unit:
Firmware has been updated to current version.
o
Nuts and tilting units of the ST16S have been tested.
o
The motor shafts and propellers are in good condition.
o
The battery packs are properly installed and snap into place.
o
The landing gear is in a good condition, and is properly extended and retracted.
o
The camera has been installed and is in good condition.
o
The camera rails are in good condition.
o
The LED indicators have been checked.
o
The telemetry function works and the data recorded with it is correct.
o
The commissioning sequence is normal.
o
The accelerometer has been successfully tested.
o
Compass calibration was checked.
o
The GPS signal has found and detected enough satellites.
o
The stationary floating test was carried out.
o
The image acquisition was tested from above.
o
The function and quality of the camera have been tested.
o
How good the response of the aircraft is in manual mode or without GPS was
o
tested.
The WayPoint / Survey function has been tested.
o
RTL and automatic landing have been tested.
o
GPS was retrieved during flight.
o
It has been tested whether the motors and the battery have a normal
o
operating temperature.
The video / image recordings were examined for discrepancies.
o
The device was cleaned.
o
Maintenance performed by:
Remarks:
Date:
Serial number
Date:
10