Panasonic CF-D1G Series Operating Instructions Manual page 16

Installing Software
n Hard disk (Flash memory) recovery
You.can.reinstall.the.OS.that.was.pre-installed.at.the.time.of.purchase.(Windows.8.1.or.Windows.7).
CAUTION
l. If.the.recovery.partition.is.deleted,.you.cannot.perform.hard.disk.(flash.memory).recovery.
Preparation
l. Connect.the.external.keyboard.and.the.mouse.
l. Remove.all.peripherals.
l. Connect.the.AC.adaptor.and.do.not.remove.it.until.installation.is.complete.
.If.reinstallation.using.the.method.described.in."Remove.everything.and.reinstall.Windows".above.is.not.
successful,.follow.the.steps.below.
1 Start the Setup Utility.
A.Display."Charm",.and.touch. .-.[Change.PC.settings].-.[Update.and.recovery].-.[Recovery].
B.Touch.[Restart.now].under."Advanced.startup".
C.Touch.[Troubleshoot].-.[Advanced.options].-.[UEFI.Firmware.Settings].-.[Restart].
Turn.on.the.computer,.and.touch.[Click.here.for.Setup].that.appears.at.the.top.left.corner.of.the.screen.while.
[Panasonic].boot.screen.is.displayed.
l. If.the.[Panasonic].boot.screen.is.not.displayed,.as.soon.as.the.computer.starts.up,.press.
until.the.Setup.Utility.screen.appears.
l. If.the.password.is.requested,.enter.the.Supervisor.Password.
2 Write down all of the contents of the Setup Utility and double-touch [Load Default Values].
At.the.confirmation.message,.select.[Yes].and.press. Enter .
3 Check the [UEFI Boot] setting of the Setup Utility.
[UEFI.Boot].should.be.set.to.as.follows.
When.Windows.8.1.is.used.:.[Enabled]
When.Windows.7.is.used. :.[Disabled]
4 Touch [Exit] and double-touch [Save Values and Reboot].
At.the.confirmation.message,.select.[Yes].and.press. Enter .
Computer.will.restart.
5 Touch top left of the screen while [Panasonic] boot screen is displayed.
The.Setup.Utility.starts.up.
l. If.the.password.is.requested,.enter.the.Supervisor.Password.
6 Touch [Exit] and double-touch [Recovery Partition].
7
Click [Next] and click [YES].
Click [Reinstall Windows] and click [Next].
8 At the License Agreement screen, click [Yes, I agree to the provisions above and wish
to continue!] and click [Next].
9 Click [Next].
If.the.option.is.displayed,.select.the.setting.and.click.[Next].
l. [Reinstall.Windows.to.the.System.Disk.to.factory.default.]
Select.this.option.when.you.want.to.install.Windows.to.the.factory.default..After.installation,.you.can.create.a.
new.partition..For.how.to.create.a.new.partition,.refer.to."To.change.the.partition.structure".(è.page.10).
l. [Reinstall.to.the.OS.related.partitions.]
Select.this.option.when.the.hard.disk.has.already.been.divided.into.several.partitions.and.you.want.to.
keep.the.partition.structure..For.how.to.create.a.new.partition,.refer.to."To.change.the.partition.structure".
(è.page.10).
. This.does.not.appear.if.Windows.cannot.be.installed.to.the.recovery.partition.and.the.area.usable.by.Windows.
*1
10 At the confirmation message, click [YES].
11
<For localized OS model>
Select OS (32bit or 64bit) and click [OK].
<For MUI OS model>
Select language and system type (32bit or 64bit) and click [OK].
At.the.confirmation.message,.click.[OK].
To.cancel.the.recovery.procedure,.click.[CANCEL],.and.click.the.
of.the.screen.
16
*1
.several.times.
.mark.that.appears.at.the.top.right.corner.