Table of Contents
Advertisement
EN 14
5.
3139 785 31640
5.
Service Test Program
To start service test program
open the tray with remote control
or front panel key, while plugging
in the mains cord press 2, 5 8 on
remote control, the tray will close
by itself and the set will display
shown "S-Vxx-yy"
Display shows
"SERVICE"
followed by ROM version
"S-Vxx-yy"
Main Menu
Display Test
key
"DisplayTest"
triggered?
y
Activate and display
"Pattern1"
key
"DisplayTest"
triggered?
y
Activate and display
"Pattern2"
key
"
"
triggered?
y
Service Test Program
S
refers to Service Mode
V
refers to Version
xx refers to Software version number of BEA
(counting up from 01 to 99)
yy refers to Software version number of Front uP
(counting up from 01 to 99)
5.1
Display Test
Purpose:
This test is used to check the driving circuits, the display and whether there are
any short-circuits, open-circuits or any other defects.
Player:
Following display patterns are used to test the display and its connections to µP.
Pattern 1:
Default: All display control pins are ON
-
to check the open-circuits
n
Pattern 2:
Alternate display control pins are on (Test Pattern: 0x55)
-
to check the short-circuits on Data port
Receiver:
n
Following display patterns are used to test the display and its
Pattern 1:
Default: All display control pins are ON
-
to check the open-circuits
Pattern 2:
Alternate display control pins are on (Test Pattern: 0x55)
-
to check the short-circuits on Data port
n
TEST
EEPROM FORMAT
TEST
ROTARY
ENCODER TEST
LEAVE SERVICE
TEST PROGRAM
Activated with
ACTION
Load default data. Display shows "NEW".
Caution!
to Exit
All presets from the customer will be lost!!
Volume
Display shows value for 2 seconds.
Knob
Volume values increases or decreases in
steps of 1
until 0 (VOL MIN) or 40 (VOL MAX) is
reached.
Disconnect
mains cord
LX8300SA & LX8320SA & LX8500W_Service Test Program_dd wk0429
connections to µP.
Advertisement
Table of Contents
