Advertisement
Installing or upgrading the wireless card
To install or upgrade a full-size M.2 SSD:
Your VivoMini includes a mini-PCIe slot for half-size wireless and Bluetooth adapters.
1.
Follow steps 1-5 on pages 2-3 under the Installing or upgrading memory modules section
of this guide to remove the bottom cover of your VivoMini.
Refer to http://www.asus.com for the list of compatible wireless and Bluetooth adapters.
2.
Align and insert the full-size M.2 SSD into its slot inside the VivoMini. Refer to the illustration
for its location.
To install or upgrade the wireless card:
1.
Follow steps 1-5 on pages 2-3 under the Installing or upgrading memory modules section
of this guide to remove the bottom cover of your VivoMini.
2.
Align and insert the wireless card into the lower slot inside the VivoMini.
3.
Gently push down the full-size M.2 SSD on top of the screw hole and fasten it using one
of the 3mm round screw. Refer to the illustration for the location of the screw hole.
3.
Gently push down the wireless card on top of the screw holes and fasten it using a
3mm round screw.
4.
Follow steps 7-8 on pages 4-5 under the Installing or upgrading memory modules section
of this guide to replace the bottom cover back on your VivoMini.
7
8
Installing 2.5" HDD
4.
Connect the black antenna to MAIN or
and the white antenna to AUX or
. Refer
to the illustration for the right installation procedure.
To install the 2.5" HDD:
NOTE: A soft clicking sound indicates that the antenna has been securely attached on
the wireless card.
1.
Follow steps 1-5 on pages 2-3 under the Installing or upgrading memory modules section
of this guide to remove the bottom cover of your VivoMini.
2.
Align the bundled bracket on each side of the HDD and insert four (4) screws to secure
the 2.5" HDD to the bracket.
3.
Connect the bundled HDD cable to the HDD, then secure the HDD and bracket to the
bottom cover of your VivoMini using the four (4) bundled screws.
5.
Follow steps 7-8 on pages 4-5 under the Installing or upgrading memory modules section
of this guide to replace the bottom cover back on your VivoMini.
9
10
4.
Remove the tape covering on the HDD cable and stick the cable to the bottom cover of
6.
Lift the SATA connector latch up (A) before inserting the HDD cable, then insert the
your VivoMini as shown in the illustration below.
HDD cable into the connector and push the latch down to secure the HDD cable (B).
5.
Remove the three (3) screws from the USB 3.0 expansion card and remove the USB 3.0
expansion card.
7.
Replace the USB 3.0 expansion card and secure it with the screws removed before..
8.
Follow steps 7-8 on pages 4-5 under the Installing or upgrading memory modules section
of this guide to replace the bottom cover back on your VivoMini.
11
12
Advertisement
