EAGTAC D25A Instruction Manual

"No Hassle" EagleTac Warranty
For repair, replacement, or other inquiries
contact your EagleTac dealer. You can also
reach our customer support via email at
support@eagletac.com.
We warrant our flashlights to be free from
defects in workmanship and materials. We
will repair, replace at our option, without
charging any product or part which is
found to be defective under normal use
within 120 months from the date of
purchase with the proof of purchase.
Electronics, chargers and rechargeable
batteries are covered for a period of 12
months with purchase receipt. Such repair
or replacement shall be the purchaser's
sole and exclusive remedy under this
warranty. Normal wear and tear including
batteries draining is not covered, nor is
damage resulting from modification,
misuse, abuse, neglect, battery leakage,
improper maintenance or repaired by
anyone other than EagleTac.
D25 clicky - Quick Specifications
D25A
110/122*
MAX O.T.F. lumen
Runtime
1.3 - 150 hrs
Battery Types
1xAA
Voltage
0.9V-1.5V & li-ion**
D25C
219/277*
MAX O.T.F. lumen
Runtime
0.9 -150+ hrs
Battery Types
1xCR123A
Voltage
1.8V-3.2V & li-ion**
*Out-the-front lumen for CREE XP-G S2 / CREE XM-L U2 respectively
**(P25A/P25C) When using single protected 3.7V rechargeable li-ion,
medium brightness level will become turbo output. ***D25LC2 only
Caution when using Li-ion in D25A & C
Using 3.7V li-ion direct drives the LED
at maximum current level. Limit each
usage to less than five minutes (or less
than one minute each with freshly
charged li-ion for the first couple
times). Hold the light in your palm to
help removing heat from the LED
faster. If you find the flashlight too
warm to hold, turn off the light to
allow the light to cool down. Do not
leave the light running unintended.
D25A2
220/278*
1.4 - 200+ hrs
2xAA
1.8V-3.2V
D25C2/D25LC2
343/548*
1 - 100+ hrs
2xCR123A/18650
***
2.7V-9V
Instruction Manual
D25 models
D
series - Clicky
High Performance Tactical Flashlights
http://www.eagletac.com
Battery Safety Precaution
WARNING - All batteries (especially
lithium and Li-ion cells) can explode
or cause burns if disassembled,
shorted, or exposed to high tempera-
ture. Do not mix new and used cells
or different battery types/voltage, or
install battery backwards.
WARNING - Some NiMH rechargeable
cells may release
discharge. If you experienced high
pressure being built inside the light,
switch off the flashlight immediately
and release the pressure gently.
Replace batteries if necessary.
EagleTac flashlights use "button-top"
battery (battery with protruding posi-
tive). For rechargeable li-ion battery,
use only EagleTac li-ion battery to
ensure safety, high performance, and
good battery fitment. Always ensure
the battery outer wrapping is com-
plete to prevent short circuit. When
the light output starts to dim, replace
batteries and do not drain the batter-
ies completely, especially when using
two (or more) batteries setup.
EAGTAC
gas during