Table of Contents
Advertisement
Engine filler
cap
and dipstick.
1.
LUBRICATION
GUIDE
-Before
Each Use
Check the oil (with the engine stopped) and add sufficient
new oil to bring it to the "FULL"
mark on the dipstick.
Do
not overfill.
Do not operate
the engine
if the oil level is
below the "LOW"
mark on the dipstick.
-After
Every 10 Hours of Operation
Use IH 251 H EP grease or equivalent
No.2 multi-purpose
lithium
grease and apply sufficient
grease to flush out old
grease and dirt.
2-
Steering
knuckles
(2).
(Both sides)
NOTE: After the first 10 hours only, remove the oil filterand
replace with a new filter.
Refer to "MAINTENANCE."Change
the oil filter after 50 hours and every 100 hours of
operation
thereafter.
3-
Transmission oil filter.
Use IH 251 H EP grease or equivalent
No.2 multi-purpose
lithium
grease and apply sufficient
grease to flush out old
grease and dirt. NOTE: It may be necessary
to rotate the
front axle to reach the grease fitting.
After Every 25 Hours of Operation
4.
Front Axle pivot bolt.
(Right side)
While the oil is warm, remove the drain plug (5) and drain
all of the oil from the crankcase.
Replace the drain plug.
Refill the crankcase
with new oil up to the "FULL"
mark
on the dipstick.
Refer to the "LUBRICATION
TABLE"
for
the proper quantity
and viscosity
to use.
5-
Engine
oil drain plug.
6-
Transmission
oil leveland
fill tube.
Check the oil with the engine stopped.
Keep the lubricant
up to "FULL"
mark on dipstick
(6).
-After
Every
50 Hours
of Operation
7. Transmission
oil filter.
8- Transmission oil filter.
NOTE: After the first 50 hours only, remove the oil filter
and replace with a new filter.
Refer to "MAINTENANCE."
Change
the
oil
filter
every
100 hours
of operation
thereafter.
Every 100 Hours of Operation
Change the oil filter and replace with a new filter.
Refer to
"MAINTENANCE."
9-Steering
gear housing.
(Center
bottom)
Once a year, apply two strokes
of the lubricator,
using IH
251 H EP grease or equivalent
No.2 multi-purpose
lithium
grease.
NOTE: To locate
the lubrication
fitting,
turn the front
wheels to the maximum
right turn position.
Then reach up
under the right side of the tractor
frame to locate the fit-
ting.
Once a year, apply a small amount
of IH 251H EP grease
or equivalent
No.2
multi-purpose
lithium
grease
in theslots.
Speed Control
Linkage
10-Cam
plates.
Miscellaneous
Brake pedal shaft
Lubricate
the brake pedal shaft and linkage with eight or
ten drops of engine oil.
26
Hide quick links:
Advertisement
Table of Contents
