1. Manuals
  2. Brands
  3. CMP Manuals
  4. Lighting Equipment
  5. Brilliant wonders 25677 series
  6. Installation instructions manual

CMP Brilliant wonders 25677 series Installation Instructions Manual

Led waterfalls
Hide thumbs
Table of Contents

Advertisement

Quick Links

INSTALLATION INSTRUCTIONS

CMP 25677 SERIES

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Brilliant wonders 25677 series and is the answer not in the manual?

Questions and answers

Related Manuals for CMP Brilliant wonders 25677 series

Summary of Contents for CMP Brilliant wonders 25677 series

  • Page 1: Installation Instructions

    INSTALLATION INSTRUCTIONS CMP 25677 SERIES...

  • Page 2: Product Overview

    1. PRODUCT OVERVIEW Thank you for choosing our 25677 Series Brilliant Wonders LED Waterfall. This lighted waterfall will add a unique ambiance to your pool or other outdoor feature. In addition to our other waterfall products, this unit includes an embedded LED light that uses a wireless remote controller (Sold Separately or supplied) for convenient customer customization.

  • Page 3: Mechanical Installation

    NOTE: USE ONLY WATER THAT HAS BEEN PROPERLY FILTERED The Brilliant Wonders Series of CMP waterfalls are available in varying sizes. The units use 1.25 gallon of water per inch of waterfall width per minute – please size the pump accordingly (See Table 1 below).
  • Page 4 Leave protective covers on the waterfall face and inlet throughout the installation (to prevent debris from getting into the product). Figure 1: Protective Cap and Tongue Shown on Waterfall 3.1.1 – Layout and finishing the base for a formed substrate. The Brilliant Wonders Waterfall series has a 6”...
  • Page 5 3.1.2 Layout and finishing the base for a wall structure The wall installation is very similar to the concrete/substrate installation without the forming process. The dimensional requirements for installation will be the same. In many cases, the waterfall will be supported by the wall structure where notching may not be required (Figure 3).
  • Page 6 3.1.4 Setting the Waterfall For standard pool applications, the waterfall must be installed before the deck and coping. Place the waterfall in the notch cut in the bond beam or wall application. Utilize substrate material such as tile, thinset or mortar to make sure that the waterfall is level with the top of the upper edge of the bond beam. Fill the gaps around the unit and coat the face of the waterfall with concrete or similar material in preparation for the tiles or other material.
  • Page 7 3.1.5 Plumbing the Waterfall If multiple waterfalls are installed, a separate pump is recommended. This will also require a separate suction line to be plumbed. The dedicated pump and suction should be plumbed with a minimum of 2” schedule 40 pipe. Anti-Vortex suction covers must be used to prevent possible entrapment for each suction line that will be used in the construction.
  • Page 8 3.1.6 Plumbing Guideline Chart The water feed line from the pump should use a minimum of 1½” PVC pipe. The feed line should terminate near the center of the waterfall at the back of the bond beam. The Plumbing Guideline Chart in Table 2 will aid in the design of the waterfall plumbing.

  • Page 9: Product Number

    The valve is necessary to balance the water flow between the units. Proper placement of the valve is shown in (Figure 10). (CMP ball valve part numbers are 25800-151-000 for 1½” and 25800-210-000 for 2”).

  • Page 10: Frequently Asked Questions

    Can the lip be cut into a custom shape or radius? LED, Arch, and Rainfall style waterfalls may not be cut. Natural Wonders waterfalls and Streamfalls from CMP can be custom cut in the field or factor cut. Never cut to within less than 1.5" of the body.

Table of Contents