Download Print this page

La Gard KEYLOCK 2270 Operating And Changing Instructions

Key lock

Download this manual

OPERATING AND CHANGING INSTRUCTIONS

Key Index

Lock Operations

Open Lock

1. Insert the Setup Key (or current Operating Key) into the lock, through the

keyhole Escutcheon Cover (P/N 2226) or Escutcheon Plate (P/N 2219) on the

front of the safe door (Figure 1).

CautiOn: Never force the key into the lock. This could cause permanent

damage to the Lock or the Key. Once the Key is inserted, do not apply

inward or outward axial force to the Key. This could prevent the Lock from

opening correctly.

2. Turn the Key to the RIGHT (CW) until it stops, and the bolt is retracted.

nOte: The Key cannot be removed while the bolt is retracted.

3. Open the safe door.

Close Lock

1. Close the safe door.

2. Turn the Key to the LEFT (CCW) until it stops.

3. Remove the Key.

Set or Change Operating Key

The 2270 Keylock is shipped from LA GARD set to open with a factory Setup Key. The

Lock installation should be completed prior to setting the Lock to open with an Operating

Key. Refer to 2270 Keylock Installation Instructions (748.1210).

Escutcheon Index

KEYLOCK

2270 KEY LOCK

Figure 1

Kaba Mas LLC

Page 1 of 2

Page 1 3. Remove the Key. Set or Change Operating Key The 2270 Keylock is shipped from LA GARD set to open with a factory Setup Key. The Lock installation should be completed prior to setting the Lock to open with an Operating Key.
Page 2 The parts listed below are needed to change the 2270 from a Setup Key to an Operating Key: • Setup Key (P/N 2213) • Change Key (P/N 1307) • Operating Key (P/N depends on key length) On the Setup/Operating Keys there is a groove referred to as the Key Index. On the Escutcheon Cover or the Escutcheon Plate there is a groove referred to as the Escutcheon Index (Figure 1).